Authors Ojo KurdiDepartement of Mechanical Engineering, Faculty of Engineering, Universitas Diponegoro, Semarang, IndonesiaSri NugrohoDepartement of Mechanical Engineering, Faculty of Engineering, Universitas Diponegoro, Semarang, IndonesiaDwi Basuki WibowoDepartement of Mechanical Engineering, Faculty of Engineering, Universitas Diponegoro, Semarang, IndonesiaAudia Fhaza AnantaraDepartement of Mechanical Engineering, Faculty of Engineering, Universitas Diponegoro, Semarang, Indonesia Abstract The steam pipeline is a main component of the steam gathering system of a geothermal power plant, conveying steam from the separator to the turbine. During continuous operation at elevated pressure and temperature, the pipe is exposed to corrosion driven by the geothermal fluid and its non-condensable gases such as CO2 and H2S, which gradually reduces the wall thickness. This study examines the effect of corrosion-induced wall thickness reduction on the stress distribution of a straight steam pipeline segment at a geothermal power plant in Indonesia using the Finite Element Method (FEM). The pipe is a 12 inch SCH 80 seamless pipe made of ASTM A106 Grade B with an outside diameter of 323.9 mm and a modeled length of 7,000 mm. Two three-dimensional models were built: a design model with a wall thickness of 17.48 mm and an actual model with a wall thickness of 15.42 mm obtained from Ultrasonic Thickness (UT) inspection. Both models were simulated in ANSYS Mechanical (Static Structural) under an internal pressure of 14 barg, a temperature of 125 °C, and identical anchor and sliding supports. The maximum von Mises stress was 439.07 MPa for the design model and 498.75 MPa for the actual model and the maximum equivalent elastic strain was 0.0021954 and 0.0024938. The maximum total deformation was almost identical, 8.4159 mm and 8.4146 mm. Wall thinning therefore increases the stress and strain in the pipe wall, so periodic thickness monitoring is required. Keywords Corrosion finite element method geothermal power plant steam pipeline stress distribution ultrasonic thickness von Mises stress wall thinning Citation of this Article Ojo Kurdi, Sri Nugroho, Dwi Basuki Wibowo, & Audia Fhaza Anantara. (2026). Analysis of the Effect of Corrosion-Induced Wall Thickness Reduction on the Stress Distribution of a Geothermal Steam Pipeline Using the Finite Element Method. International Current Journal of Engineering and Science (ICJES), 5(11), 14-18. Article DOI: https://doi.org/10.47001/ICJES/2026.511002 Licence Copyright (c) 2026 International Current Journal of Engineering and Science. This work is licensed under a Creative Commons Attribution Non Commercial 4.0 International Licence. References S. J. Zarrouk and H. Moon, “Efficiency of geothermal power plants: A worldwide review,” Geothermics, vol. 51, pp. 142–153, 2014.A. Andi, S. J. Zarrouk, and E. Kaya, “Continuum risk-based asset integrity management system for geothermal steam pipelines: Kamojang Unit 4, Indonesia,” Geothermics, vol. 96, Art. no. 102190, 2021.M. R. Firdaus, N. Hidayati, and A. Ekayuliana, “Analysis of the effects of CO2, H2S composition, and temperature on steam towards corrosion rate in geothermal power plants,” J. Energy Mater. Instrum. Technol., vol. 4, no. 4, pp. 163–168, 2023.G. Aristia, L. Q. Hoa, and R. Bäßler, “Corrosion of carbon steel in artificial geothermal brine: Influence of carbon dioxide at 70 °C and 150 °C,” Materials, vol. 12, no. 22, Art. no. 3801, 2019.R. N. P. Gunarathna and V. Sivahar, “Challenges in monitoring metallic pipeline corrosion using ultrasonic waves – A review article,” Engineer: J. Inst. Eng. Sri Lanka, vol. 54, no. 1, pp. 67–75, 2021.M. Y. Matuda, N. Pérez, F. Buiochi, J. C. Adamowski, and M. S. G. Tsuzuki, “Error analysis of self-compensated ultrasound measurements of the thickness loss due to corrosion in pipe walls,” Ultrasonics, vol. 142, Art. no. 107387, 2024.T. Arumugam, S. Karuppanan, and M. Ovinis, “Finite element analyses of corroded pipeline with single defect subjected to internal pressure and axial compressive stress,” Mar. Struct., vol. 72, Art. no. 102746, 2020.A. I. Thorhallsson, A. Stefansson, D. Kovalov, and S. N. Karlsdottir, “Corrosion testing of materials in simulated superheated geothermal environment,” Corros. Sci., vol. 168, Art. no. 108584, 2020.